Synthetic blood penetration test equipment factory China? The two bursting strength testing instruments are mainly applied to test all kinds of textiles, non-woven, leather and other materials. In every direction of longitude and latitude stress (diaphragm method) at the same time, measure it’s performance of spreading force and distension. Pneumatic clamping, clamping uniform, not easy to skid, easy to use. Use AC servo drive system, stable running low noise, wide range of debugging and application. Find even more info on bacterial filtration efficiency test.
GESTER instruments is a national high-tech textile testing equipment manufacturers engaged in R&D and production of high precision physical properties textile testing instruments with 22 years experience, expertly specialized in providing integrated laboratory testing solutions for children’s products, textile, footwear and furniture. It has passed ISO 9001 certificate, “AAA Enterprise in Quality, Service and Credit” and was audited as SGS audited supplier.
The values stated in SI units are to be regarded as the standard, with the exception of mils when determining coating thickness.Test Procedure: The haze or original weight of test specimen is measured. The test specimen is then placed on the taber wear and abrasion tester. A 250, 500, or 1000-gram load is placed on top of the abrader wheel and allowed to spin for a specified number of revolutions. Different abrading wheels are specified. A haze measurement or final weight is taken. The load and wheel can be adjusted for softer and harder materials.
Correct use of computerized universal testing machine: When opening the clamp to take the sample, pay attention to the clamping distance of the sample, not too much or too little. When the tensile testing machine and the microcomputer are connected, the operation must be carried out according to the program requirements. It is strictly forbidden to operate the program due to illegal operation; The parameters to be printed check whether the printer has paper and replenish it in time before printing. After the operation is completed, shut down the tensile testing machine for rubber according to the program requirements. It is strictly forbidden to cut off the power directly.
Gauge length and tension speed presettable; Able to set pre-tensile force; Many kinds of clamp are selectable according to requirements test standards, including pneumatic clamps. Textile fabric, such as bedsheets, clothes, etc., a lot of them will lose color after washing, some products fade seriously, even after washing many times, there will still be discolored. Test Preparation before Color Fastness to Washing. What test standards are there? Color fastness to washing is one of the common test items for textile dyeing fastness, which is mainly used to test the fastness of fabric clothing and home textile products after one or more times to simulate the dyeing after household washing and commercial washing. There are three common standard: AATCC 61, ISO 105 C06, GB/T 3921.
Pneumatic Bursting Strength Testing Machine For determining the bursting strength of woven or knitted fabrics, non-woven, paper, leather and board by application of a pneumatic load under a rubber diaphragm of a specific area. Provide with a digital readout of pressure with peak value hold facility, renewable rubber diaphragms, and manual clamping device with acrylic bell, forward reverse and neutral drive system. Provide accurate elongation information of fabrics, up to 0.1mm. Read even more details on https://www.gesterinstruments.com/.